Window Air Conditioner Water Leaks

Posted by on May 4, 2015 in AC Repair Irvine CA, Air Conditioning Maintenance

An air conditioner can catch lots of water while it is getting rid of moisture, or humidity, from the air on the inside of the household. Regarding window air conditioners, the water collected through typical running moves down the AC coil and drops into the base, and is then directed to the back. Most of the water is raised up by the fan blade and put to use to cool the heating coil, while most of it travels to the rear where it drains outside of the residence. However, for the occasions when water is leaking within the house from a window AC unit, here are AC Repair Irvine CA’s strategies on easy methods to troubleshoot the scenario.

Finding the source of an Irvine air conditioner leak can be difficult, for it can seem like it is coming from more than one location, and only happen occasionally. Below are a few strategies for the most frequent causes why water leaks take place with an air conditioning unit.

1. Incorrectly installed
For window air conditioners, they ought to be installed in order that the back of the unit is a little lower than the front. Doing this enables the water being removed to drain to the back of the unit. A level variation of one inch is effective. Take a look at this initially. Water will run right into the room and not outdoors if installed too low at the front.

2. Icing up
Water that is being removed from the air within the room can turn to ice if the AC is no longer working accurately. Take off the front grill while the unit is working to notice if ice is found. There are numerous causes this sometimes happens and it will be best to contact us to have a look at the AC unit.

3. Air leaks about air conditioner
If warm air from outside is capable of entering within through around the air conditioner it will combine with the cooler, dryer indoor air. Condensation will arise when the 2 distinct temperature airs meet. If water is leaking from the front of the air conditioner look at it to find out whether it is dripping from the body of the machine, or if water droplets are adhering to the front. To check this, operate the AC unit for thirty minutes then examine underneath the front edge of the base with a flashlight for water droplets. If water droplets are existing, there is an air leak situation. By adding foam insulation all around the unit prevents warm air from getting in.

4. Drain hole blockage
The back of the air conditioner base contains a drain hole that permits water to drain. If this gets clogged water may back up. To run a test, run the AC unit for A half-hour and then examine to check if it is draining correctly. The base ought to hold a considerable volume of water, but it ought not be entirely full of water. If it seems obstructed use a small piece of wood to unclog the drain hole.
5. Internal drains blockage
One can find little passageways that enable water to drain through the front of an AC unit to the back. If they are clogged, water will accumulate at the front of the unit and overflow. Should this happen, usually we will need to take out the air conditioner to service it. To evaluate, run the system for A half-hour and then take off the front filter and plastic cowling. In case the front of the base is totally full of water, but there exists only a little water leaking from rear of unit on the floor, there could possibly be a clogged passageway.

6. Outside temperature is too cold
This difficulty is more prevalent close to the end of the cooling time of year. When outdoor temperatures are under 60 degrees Fahrenheit during the night time the coil could ice up. If one doesn’t discover any water leaks prior to going to bed, but there is water in front of the machine in the morning, this is perhaps the situation. Simply switch off the AC unit prior to bedtime and only operate it as needed throughout the day.